วันศุกร์ที่ 8 เมษายน พ.ศ. 2554

Maintenance, skins and sharpening of a razor

Maintenance, skins and sharpening of a razor

Maintenance, skins and sharpening of a razor

Posted: 08 Apr 2011 01:01 PM PDT

The shaver is a traditional accessory that man must be properly maintained to ensure a sharp edge. The cutting geometry is carefully designed to give a perfect edge with little effort over time, but this does not mean that maintenance with a razor.

The level of maintenance depends on the material razor blade. Some are made of stainless steel, which require less maintenance because they do not rust. More razor be rinsed in water and driedthoroughly between applications. Not a wet razor. If you do not use the razor for a long time, rub with mineral oil. 6:00 to 15:00 are anywhere close shaves points as possible without sharpening or removed.

If you start the razor with your skin when you pull, it's time to sharpen and strop it. Before removing or sharpen your razor blade, let it sit for at least 24 to 48 hours after the lastto use. There is a nice "fin" on the cutting edge, which must rest between applications. If you try to sharpen the razor too soon after use, the fin is broken and will not be able to get a shave with a razor, dass

To sharpen sharpening the blade or use a bow. It is a strip of fine leather. The skin can be rubbed with a special grinding or polishing agents. A strop is used to obtain very sharp, smooth edge of a razor. When you check out a razor,the blade held flat against the skin with the back of the knife against the strop. E 'pulled away from the body, and then turned around and pulled on the body. At the end of the race, hold the blade in contact with the strop. Turn the knife along the back edge (not the edge) so that it now is in your path, instead of away from you. If you are not the knife, before drawing a razor blade to the body will damage the cutting edge. A stropis for routine maintenance and should be done at least every ten shaves or so. Repeat for at least ten to twenty times every time the razor strop.

If the motor is very boring, or has been dropped or otherwise acquired in a severely damaged edges, a pendant is not able to improve the cutting edge. Instead, you have a stone knife sharpening or take your razor to a specialist. A grinder may be required to state the recovery of yourRazor, if the edge is serrated as strong as when it opened and was then dropped from a distance onto a hard surface.

To grind or work to improve an edge, the blade is completely flat against the stone. Push forward, toward the edge. At the same time, move diagonally across the stone, so is the fact that the entire cutting board from side to side in contact with the stone. Repeat this process about 10 to 20 times. It is necessary to ensurethe razor completely flat against the stone, so that the blade touches the stone. Do not press against the tide when grinding, its weight, the blade is enough pressure, the more weight deforms the circle.

เขียนโดย ที่

ไม่มีความคิดเห็น:

แสดงความคิดเห็น

สมัครสมาชิก: ส่งความคิดเห็น (Atom)